ISO 2808-7B, BS 3900-C5 method 7B, ASTM D4414-A specify that the wet film wheel should be perpendicular to the substrate and the thickness of the coating should be stated as that indicated on the central wheel - ensuring that the wheel has been rolled from maximum thickness to minimum thickness - thus avoiding surface tension.
Example
Hold the wheel by its central spindle. Begin at maximum thickness to reduce risk of inaccuracy caused by surface tension.
Roll the wheel through the wet film with the side 1 in the diagram touching the substrate. Roll for at least one whole turn and slowly enough for wetting to occur. Roll the wheel backwards by at least on complete turn. The wet film thickness is read from the scale, at the end of the wetted segment of the middle circle, 2 in the diagram
To use wheel on pipes, measure across the longitudinal axis (lengthways) of the pipe.
On rough surfaces, measurements will be made from the surface peaks and represent the minimum wet film thickness.
Elcometer 3230 卷材涂料湿膜轮-技术参数
| 型号 |
分类 |
量程 |
分度 |
订货编号 |
| Elcometer 3230/17 |
Elcometer 3230 湿膜轮-卷材涂料 |
0~50μm |
2.5μm |
sz1404-1 |
| Elcometer 3230/18 |
Elcometer 3230 湿膜轮-卷材涂料 |
0~100μm |
5.0μm |
|
| Elcometer 3230/19 |
Elcometer 3230 湿膜轮-卷材涂料 |
0~300μm |
15.0μm |
|
| Elcometer 3230/17a |
Elcometer 3230 湿膜轮-卷材涂料 |
0~2mils |
0.1mils |
|
| Elcometer 3230/18a |
Elcometer 3230 湿膜轮-卷材涂料 |
0~4mils |
0.2mils |
|
| Elcometer 3230/19a |
Elcometer 3230 湿膜轮-卷材涂料 |
0~12mils |
0.5mils |
|
| 附件 |
50cm（19″）湿膜轮手柄 |
|
| 100cm（39″）湿膜轮手柄 |
|
